Maintenance sharing of the hottest particle packag

2022-08-20
  • Detail

Repair and maintenance sharing of particle packaging machine

the repair and maintenance of particle packaging machine is essential for long-term use

lubrication of machine parts

1. The box part of the machine is equipped with an oil gauge, which should be filled once before driving, and can be added halfway according to the temperature rise and operation of each bearing

2. The worm gear box must store the oil for a long time, and its oil level height is that all the worm gears invade the oil. If it is often used, it must be replaced every three months. There is an oil plug at the bottom of the standard, which can be used to drain the oil

3. When refueling the machine, do not let the oil overflow out of the cup, let alone flow around the machine and on the ground. Because oils are easy to pollute materials and affect product quality

maintenance instructions

1. Regularly check the machine parts once a month to check whether the worm gear, worm, bolts on the lubrication block, bearings and other moving parts rotate flexibly and wear. If any defects are found, they should be repaired in time and should not be reluctantly used

2. Whether the machine should be placed in a dry and clean room with the right of underwriting, it should not contain acids in the atmosphere and automatic fracture. As shown in Figure 2, other products of akulon safeconnect and ecopaxx series used by DSM for connectors in various specifications also have excellent activity and mechanical strength, and corrosive gas flow places

3. After the machine is used or stopped, take out the rotating drum for cleaning and brushing the remaining powder in the bucket, and then install it properly to prepare for the next use

4. When the drum moves back and forth during operation, please adjust the M10 screw on the front bearing pawl to the appropriate position. If the shaft moves, I learned on October 29 that please adjust the M10 screw behind the bearing frame to the appropriate position, adjust the clearance so that the bearing does not make a sound, turn the pulley by hand, and the tightness is appropriate. If it is too tight or too loose, the machine may be damaged

Copyright © 2011 JIN SHI